TCP/IP SETTING MANUAL

Based on the question:

 In this section, we are assumed to have correctly identified the IP address for the OnlineLearning System Server. Therefore, we must produce a manual on how to configure the IP address on the server. we can use any operating system to demonstrate this task. The explanation should be supported with screenshots and appropriate explanations.

 

HERE ARE THE STEPS 

STEP 1 : OPEN THE COMPUTER SETTING AND THEN SEARCH FOR CONTROL PANEL AND OPEN IT.

STEP 2 : THEN CLICK NETWORK AND INTERNET. 

STEP 3 : CLICK THE NETWORK AND SHARING CENTER.

 

 

 

STEP 4 : ON THE SIDE LEFT OF THE WINDOW, CLICK  THE CHANGE ADAPTER SETTINGS

STEP 5 : AFTER THAT, DOUBLE CLICK ON THE ENTHERNET 2

 

 STEP 6: CLICK ON THE PROPERTIES. AFTER THAT, CHOOSE TCP/IPV4 INTERNET PROTOCOL VERSION 4

 STEP 7 : TO CONFIGURE OUR OWN CONFIGURATION, CHOOSE USE THE FOLLOWING IP ADDRESS SO THAT WE CAN CONFIGURE IT MANUALLY.

 

Based on what have calculated from the Subnetting Calculation, our IT Center is ranges from 192.168.0.224 until 192.168.0.255. For this purpose, we will choose 192.168.0.226 as our IP address for this specific host/device. Since the IP address class is Class C, our Subnet mask will be 255.255.255.0. For Default gateway and DNS server, we will use the first IP address from the IT Center address which is 192.168.0.244. Then we will click OK to apply the changed IPv4 configuration.  

 

STEP 8 : TO VERIFY THE CONFIGURATION, 

OPEN COMMAND PROMPT AND ENTER THE COMMAND ipconfig/all.

It will shown that the IPv4 address, Subnet mask and Default gateway have changed.